Problem with my HDD and FS's after upgrade and cloning the..

Hi all,
I use the Debian Lenny AMD64 on my laptop Acer TravelMate 3043.
After upgrading from my old HDD 120GB to 500GB and cloning the first to
the last, I have the next problem:
sudo fdisk -l

Disk /dev/sda: 500 GB, 500105249280 bytes
255 heads, 63 sectors/track, 60801 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

Device Boot Start End Blocks Id System
/dev/sda1 1 509 4088511 12 Compaq diag
/dev/sda2 * 510 5214 37784880 c FAT32 LBA
/dev/sda4 5215 53727 389672640 5 Extended
/dev/sda5 5215 5257 337365 83 Linux
Warning: Partition 5 does not end on cylinder boundary.
/dev/sda6 5258 5865 4875727 83 Linux
Warning: Partition 6 does not end on cylinder boundary.
/dev/sda7 5866 6230 2923830 83 Linux
Warning: Partition 7 does not end on cylinder boundary.
/dev/sda8 6231 6399 1349460 82 Linux swap
Warning: Partition 8 does not end on cylinder boundary.
/dev/sda9 6400 6448 385560 83 Linux
Warning: Partition 9 does not end on cylinder boundary.
/dev/sda10 6449 53727 379760535 83 Linux
Warning: Partition 10 does not end on cylinder boundary.
/dev/sda3 53728 60801 56813872 c FAT32 LBA

Some people tell me that the "Partition x does not end on cylinder
boundary" is not serious problem and advise me to do not call attention
to that.
But some other people tell my FS's can crash through that and reccomend
me to reinstall my system at all.
What can you advice me with that?


--
To UNSUBSCRIBE, email to debian-laptop-REQUEST RemoveThis @lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster RemoveThis @lists.debian.org